INSTALLATION GUIDE
Item No.:PSWLE55
Thank you for choosing our product
Pyle Audio
1600 63rd st , Brooklyn, NY, 11204
(718)236-8000
TV Size Range: 36"～55"
Maximum Weight Capacity: 35kg/77lbs
Locked by safety bolt on the bottom
Balance adjust system is included
Warning
This product contains small items that could be a choking hazard if swallowed. Keep
these items away from young children!
1.Make sure these instructions are read and completely understood before attempting
installation. If you are unsure of any part of this installation, contact a professional
installer for assistance.
www.pyleaudio.com
CAUTION
2.The wall or mounting surface must be capable of supporting the combined weight of
the mount and the display; otherwise the structure must be reinforced.
3.Safety gear and proper tools must be used. A minimum of two people are required
for this installation. Failure to use safety gear can result in property damage, serious
injury or death.
This product was designed to be installed on wood stud walls and solid concrete walls.
Before installing make sure the supporting surface will support the combined load of the
equipment and hardware. Never exceed the Maximum Load Capacity. This product is
intended for indoor use only. Use of this product outdoors could lead to product failure or
personal injury.
-8-
Part 1aa-Wood SStud Moouunting
Part 2bb-Attaacching brracketts to scrreen wiith reccessed back
Use wall plate as a template, make sure it is level, and mark mounting holes
along the center lines of the wood studs. Drill 3/16”(5mm)dia.holes 2”
(50mm) deep. Level wall plate and attach to wall with long bolts(J) and
washers(L). Tighten screws firmly. Do not overtighten.
Center brackets vertically on back of screen. Select the medium(F or G) or
large(H) screws. Attach brackets to screen using four selected screws,four
square washers(I) and four spacers(M) at the top and bottom of each bracket.
Tighten screws firmly. Do not overtighten.
Square washer(I)
2”(50mm)
Large hole for
M8 screws
Φ3/16”(5mm)
Medium hole for
M5 and M6 screws
M
F-H
I
Wood stud
Bubble level
L
J
-3-
-6-
Part 1b--Concrette Wall MMoounting
Part 2aa-Attaachingg Brackeets To SScreenn WWith Fllat Back
Level wall plate and use it as a template to mark holes. Drill 3/8”(10mm) dia.
holes 2”(50mm) deep. Insert anchors(K) into holes and secure wall plate
with long bolts(J) and washers(L). Tighten screws firmly. Do not overtighten.
Center brackets vertically on back of screen. Select the small(A or B),medium
(C or D) or large(E) screws. Attach brackets to screen using four selected
screws and four square washers(I) at the top and bottomof each bracket.
Tighten screws firmly. Do not overtighten.
Square washer(I)
2” (50mm)
Large hole for
M8 screws
Φ3/8”(10mm)
Medium hole for
M5 and M6 screws
Small hole for
M4 screws
A-E
I
Concrete Wall
K
L
Bubble level
J
-5-
-4-
|