Sea Dragon Mini 650 Underwater Light
(Item SL650 and SL651)
Instruction Sheet
Step 1: Install 2 disposable CR123 batteries or 1 Tenergy 30049 Li‐ion 18650 3.7V 2600mAh rechargeable battery (sold seperately).
Step 2: Long press the power
Step 3: The light uses two O‐rings to maintain a waterproof seal.
button to power light on and off.
1) O‐rings and sealing surfaces must be perfectly clean.
2) Inspect o‐rings for cuts, tears or other damage and replace if damaged or
at least once a year (item SL98103).
3) Lube O‐rings lightly before each use.
Note: Quick press power button
to change light modes: 100%
power → 40% power →Blinking.
Step 4: Use Y‐S adapter to mount
light to SeaLife AquaPod®, camera
housing cold shoe or GoPro®
camera.
Important:
1) After each dive, soak the sealed light in fresh water for about 15 minutes
to remove any residual salt, sand and dirt. Dry light with clean towel
before opening battery compartment or storage.
2) A battery indicator light is located around power button. Green = full
power, yellow = half power and red = low power (Replace/recharge
battery)
3) Do not use rechargeable CR123 batteries. The Sea Dragon Mini 650 light
is not designed to function with this type of battery.
AquaPod®
Cold shoe
Guarantee: SeaLife warrants the original purchaser of this product, for a period of
one (1) year from the date of purchase, that the product is free from defects in
workmanship and materials. In the event the original purchaser believes there is a
cameras.com for product updates and information on how to get warranty repair
service. Please contact your local SeaLife dealer or the importer in the country where
the product was purchased for return information.
GoPro® camera
SeaLife (Div. of Pioneer Research), 97 Foster Road, Moorestown, NJ 08057 USA www.sealife‐cameras.com
Revised April 2015
|