You are now the proud owner of a SEIKO Automatic Diver’s Watch
Cal. 7S26. For best results, please read the instructions in this booklet
carefully before using your SEIKO Automatic Diver’s Watch. Please
keep this manual handy for ready reference.
Usted es ahora un honrado poseedor del reloj de buceador automatico
SEIKO Cal. 7S26. Para obtener de él los mejores resultados, lea las
instrucciones del presente folleto con cuidado antes del uso de su reloj
de buceador automatico SEIKO. Guarde este manual para fácil referencia.
SEIKO AUTOMATIC DIVER’S WATCH
Cal. 7S26
Minute hand
Hour hand
Day and date
Rotating bezel
MON 15
a
b
c
d
Second hand
Crown
a: Screwed-in position
b: Normal position
c: First click
d: Second click
3
FEATURES
200 METER WATER RESISTANCE
SCREW DOWN CROWN
TIME/CALENDAR
● Suitable for scuba diving
ROTATING BEZEL
● Hour, minute & second hands
● Elapsed time measurement during
diving (up to 60 minutes)
● Date
● Day
REMARKS ON LUMINOUS PAINT
◆
Your SEIKO Automatic Diver’s Watch uses promethium-147 as the active ingredient in the
luminous paint.
The use of radioactive materials such as promethium-147 is strictly regulated by
Japanese Law and monitored by the Japanese Science and Technology Agency. SEIKO
luminous watches, manufactured in accordance with the law, contain an approved
amount of promethium-147 harmless to human beings. The amount of radiation they
emit also conforms to the standards specified by the US Nuclear Regulatory Commission.
NOTE: Japanese regulations on the use of radioactive materials enforced by the Japanese
Science and Technology Agency are equivalent to or even stricter than similar
regulations of the IAEA and ISO.
4
HOW TO START THE WATCH
This is an automatic mechanical watch.
● To initially start your watch:
Swing it from side to side in a horizontal arc for about 30 seconds.
* If the watch is worn on the wrist, the mainspring will be wound automatically through normal wrist
movement.
5
TIME/CALENDAR SETTING
Unlock the
crown by
turning it
Pull out the
crown to the
first click.
Set the previous
day’s date.
Set the previous
day of the week.
3
1
2
4
counterclockwise.
MON 15
2
3
1
4
6
Pull out the
crown to the
second click.
Turn the hands
until the desired
date and day
appears.
Set the hands
to the desired
time.
Push back the
crown.
5
6
7
8
9
Lock the crown
by turning it
clockwise while
pressing it.
MON 16
5
6
7
9
8
7
ROTATING BEZEL
The rotating bezel can show up to 60 minutes of elapsed time.
Turn the rotating bezel to align its Read the number on the rotating
“
” mark with the minute hand.
bezel that the minute hand points
to.
1
2
Minute hand
Start
Elapsed time
30 minutes
have elapsed.
8
PRECAUTIONS
CAUTION
Diving is an inherently hazardous form of recreation and it is essential that you
strictly observe all instructions for use and maintenance of the watch set forth in
this booklet for safety’s sake. DO NOT ATTEMPT TO DIVE USING THIS WATCH
UNLESS YOU HAVE BEEN PROPERLY TRAINED IN DIVING.
Do not use the watch for saturation diving using helium gas.
BEFORE DIVING
● Check that:
• the watch operates normally.
• the crown is locked tightly in place.
• there are no visible cracks in the crystal or the watch band.
• the strap or bracelet is securely fastened to the watch case.
• the buckle keeps the strap or bracelet firmly secured to the wrist.
• the rotating bezel turns counterclockwise smoothly (the rotation must not be too loose or too tight)
and the “
” mark aligns with the minute hand.
• the time and calendar are appropriately set.
If there are any malfunctions, we recommend that you contact an AUTHORIZED SEIKO SERVICE
CENTER.
9
WHILE DIVING
● Do not operate the crown when the watch is wet or in water.
● Take care not to hit the watch against hard objects such as rocks.
● Bezel rotation may become slightly harder in the water but this is not a malfunction.
AFTER DIVING
● After checking that the crown is screwed in completely, rinse the watch in fresh water, and wash out all
seawater, soil, sand, etc.
● After cleaning the watch in fresh water, be sure to wipe it thoroughly dry to prevent possible rust on the
case.
10
NOTES FOR USING THE WATCH
HOW TO START THE WATCH
● If the watch is used without being wound up sufficiently, gain or loss of the watch may result. To avoid
this, wear the watch for more than 8 hours a day.
TIME/CALENDER SETTING
● Do not set the day between 9:00 p.m. and 4:00 a.m. Do not set the date between 9:00 p.m. and 1:00 a.m.
Otherwise, it may not change properly.
If it is necessary to set the date during that time period, first change the time to any time outside it, set
the date and then reset the correct time.
● To set the exact time, pull out the crown to the second click when the second hand is at the 12 o’clock
position and push it back in to the normal position in accordance with a time signal.
● When setting the hour hand, check that AM/PM is correctly set.
The watch is so designed that the date changes once in 24 hours. Turn the hands past the 12 o’clock
marker to determine whether the watch is set for the A.M. or P.M. period. If the date changes, the time
is set for the A.M. period. If the date does not change, the time is set for the P.M. period.
● When setting the hands, first set them to a time a few minutes earlier than the correct time, and then
advance them to the exact time.
● It is necessary to adjust the date at the end of February and 30-day months.
ROTATING BEZEL
● For safety’s sake, the rotating bezel rotates only counterclockwise, so that the time measured is never
shorter than the actual elapsed time.
11
TO PRESERVE THE QUALITY OF YOUR WATCH
● Repair of diver’s watches requires special expertise and equipment. If you find that your diver’s
watch is malfunctioning, therefore, never attempt to repair it but immediately send it to a nearby
SEIKO Service Center.
■ TEMPERATURES
Your watch works with stable accuracy within a temperature range of 5° C and
+60°C
35° C (41° F and 95° F).
Temperatures over 60° C (140° F) or below -10° C (+14° F) may cause a
-10°C
slight time loss or gain or shorten the duration within which the watch keeps
operating. However, the above conditions will be corrected when the watch
returns to normal temperature.
■ PERIODIC CHECK
■ MAGNETISM
■ CHEMICALS
2 - 3
Years
N
S
Your watch will be
adversely affected by
strong magnetism. cosmetic spray, detergents,
Keep it away from
close contact with
magnetic objects.
It is recommended that the watch
be checked once every 2 to 3 years
by an AUTHORIZED SEIKO DEALER
or SERVICE CENTER to ensure that
the case, crown, gasket and crystal
seal remain intact.
Be careful not to expose the
watch to solvents, mercury,
adhesives or paints. Otherwise,
the case, bracelet, etc. may
b e c o m e
d i s c o l o r e d ,
deteriorated or damaged.
12
■ CARE OF CASE AND
BRACELET
■
PRECAUTION REGARDING
CASE BACK PROTECTIVE FILM
■ SHOCKS &
VIBRATION
To prevent possible rusting Be careful not to drop If your watch has a protective film
of the case and bracelet, wipe your watch or hit it and/or a sticker on the case back,
them periodically with a soft against hard surfaces.
dry cloth.
peel them off before using your
watch.
SPECIFICATIONS
1
2
3
4
5
6
Vibrations per hour ............................................ 21,600
Operational temperature range ......................... –10° C ~ +60° C (14° F ~ 140° F)
Driving system .................................................. Self-winding type
Jewels ............................................................... 21 jewels
Magnetic resistance .......................................... 4,800 A/m (60 gauss)
Water resistance ............................................... Water resistant up to 200 meters
The watch is suitable for scuba diving.
* The specifications are subject to change without prior notice for product improvement.
13
|