INSTA LLATION INSTRUCTIONS FOR PA RT 9 9 -9 3 0 3
APPLICATIONS
BMW Z4
2003-2008
9 9 -9 3 0 3
KIT FEATURES
• DIN Head Unit Provision
KIT COMPONENTS
A) Radio Housing
TOOLS REQUIRED:
Small Flat Blade Screwdriver • Phillips Screwdriver
A
WIRING AND ANTENNA CONNECTIONS
(Sold Separately)
• 40-EU10 - European antenna adapter
• 70-9003 - European harness
TABLE OF CONTENTS
Dash Disassembly: pg. 1
Kit Assembly: pg. 2
Final Assembly: pg. 3
1-800-221-0932
REV. 04-17-09 © COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION
9 9 -9 3 0 3
DIN HEA D UNIT P ROVISION
A
NOTE:
The bottom bar connecting the two sides
of the 99-9303 will need to be cut and
removed prior to Kit Assembly. (Figure A)
Screw the 99-9303 housing into the
dash opening instead of the factory
1
radio. (Figure B)
B
Slide the DIN cage into the space in
2
the 99-9303 and secure by bending
the metal locking tabs outward.
(Figure C)
Slide the aftermarket head unit into
the DIN cage until secure.
3
(Figure D)
C
D
2
9 9 -9 3 0 3
A
B
A)
B)
C)
D)
Strip wire ends back 1/2"
Twist ends together
Solder
C
D
Tape
Locate the factory wiring harness in the
1
dash. Metra recommends using the proper
mating adapter and making the connections
as shown. (Isolate and individually tape off
the ends of any unused wires to prevent
electrical short circuit)
2
3
Re-connect the negative battery terminal and test
the unit for proper operation.
Reassemble radio and dash assemblies in
reverse order of disassembly.
K
NOWLEDGE IS
POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
800-354-6782 for more information and take steps
toward a better tomorrow.
3
|