|
Nokia Bluetooth Headset BH-118 User Guide
Issue 1.0
3
Introduction
About your headset
With the Nokia Bluetooth Headset BH-118, you can make and receive calls while on
the move.
Read this user guide carefully before using the product. Also, read the user guide for
the device that you connect to the product.
Warning:
This product may contain small parts. Keep them out of the reach of small children.
The surface of this product is nickel-free.
About Bluetooth connectivity
You can use Bluetooth to make a wireless connection to other compatible devices,
such as mobile phones.
Devices do not need to be in direct line-of-sight, but they must be within 10 metres
(33 feet) of each other. The connection may be affected by obstructions such as walls
or other electronic devices.
This device is compliant with Bluetooth Specification 2.1 +EDR supporting the
following profiles: Headset Profile (HSP) 1.1, Handsfree Profile (HFP) 1.5. Check with
the manufacturers of other devices to determine their compatibility with this device.
4
Get started
Keys and parts
1
2
3
4
5
6
7
Earpiece
Microphone
Earpiece holder
Multifunction key
Clip
Charger connector
Indicator light
Parts of the product are magnetic. Metallic materials may be attracted to the product.
Do not place credit cards or other magnetic storage media near the product, because
info stored on them may be erased.
Charge the battery
Before using the headset, you must charge the battery.
Warning:
Use only chargers approved by Nokia for use with this particular model. The use of
any other types may invalidate any approval or warranty, and may be dangerous. Use
of unapproved chargers may present a risk of fire, explosion, or other hazard.
When you unplug a charger, hold and pull the plug, not the cord.
1
Plug the charger into a wall outlet.
5
2
3
Connect the charger cable to the charger connector on the headset. The red
indicator light turns green when the battery is fully charged. Charging the battery
fully may take up to 2 hours.
Disconnect the charger from the headset, then unplug from the wall outlet.
The fully charged battery has power for up to 6 hours of talk time or up to 120 hours
of standby time.
When the battery charge is low, you hear a voice prompt, the headset beeps every 5
minutes, and the red indicator light flashes. When the battery is charging, the red
indicator light is on.
Check the battery charge
Make sure the headset is switched on, then press . A green light indicates a
sufficient charge level. If the light is yellow, you may need to recharge the battery
soon. If the light is red, recharge the battery.
Switch the headset on or off
Switch on
Press and hold
flashes once.
for 2 seconds. The headset beeps, and a green indicator light
The headset connects to the last connected phone or other device. If you have never
paired the headset, or you have cleared the pairings, the headset switches to pairing
mode.
Switch off
Press and hold
once.
for 5 seconds. The headset beeps, and a red indicator light flashes
If not connected to a phone within 30 minutes, the headset switches off.
Pair and connect the headset to your phone
Before using the headset, you must pair and connect it to a compatible phone.
1
2
3
Switch the headset off.
Switch your phone on.
If you have never paired the headset, or you have cleared the pairings, switch the
headset on.
If you have previously paired your headset with a device, press and hold
seconds.
for 5
6
The headset switches to pairing mode, and a green indicator light starts to flash
quickly.
4
Within 3 minutes, switch Bluetooth on in your phone, then set it to search for
Bluetooth devices. For details, see the user guide of your phone.
5
6
Select the headset from the list of found devices.
If needed, type in the passcode 0000.
You can pair your headset with 8 compatible phones, but you can only connect it to
a maximum of 2 phones at the same time.
With some devices, you may need to make the connection separately after pairing.
When the headset is paired to your phone and is ready for use, the green indicator
light flashes about every 5 seconds.
Switch the voice guidance off
If you'd prefer to use your headset without the voice prompts, you can switch them
off.
1
2
To switch the headset off, press and hold
for 5 seconds.
Press and hold
for 5 seconds. The headset switches to pairing mode, and a
green indicator starts to flash quickly.
To switch the headset on, press and hold
3
for 2 seconds.
Switch voice guidance back on
Follow the same steps used to switch voice guidance off.
Wear the headset
Use the clip to attach the headset to your clothing.
7
To have the earpiece within easy reach when not using the headset, keep the earpiece
in the holder.
Make calls
Make and receive calls
To make and receive calls using your headset, you need to connect it to your phone.
Make a call
Make a call in the normal way.
Answer or end a call
Press
.
Reject a call
Press
twice.
Switch a call from your headset to a compatible phone
Press and hold
Switch a call from a compatible phone to your headset
Press and hold for 2 seconds, or switch the headset on.
for 2 seconds, or switch the headset off.
When you're not in a call, you can redial the last called number or use voice dialling,
if your phone supports these features with the headset.
8
Redial the last called number
Press
twice.
Use voice dialling
Press and hold for 2 seconds, then follow the instructions in the user guide of your
phone.
Change the volume
Set the desired volume level on your connected phone. The selected volume level is
saved as the minimum volume level for the phone that is currently connected to the
headset.
Pair and connect the headset to two phones
When you use the headset for the first time, it automatically connects to your phone.
You can also connect your headset to another phone, and manage calls from, for
example, both your personal and your work phone at the same time.
1
2
To switch the headset off, press and hold
To activate pairing mode, press and hold
with the second phone.
for 5 seconds.
for 5 seconds, and pair the headset
3
Make sure Bluetooth is activated on both phones, and switch the headset off and
back on. The headset connects to both phones.
Handle calls from two phones
If your headset is connected to two phones, you can handle calls from both at the
same time.
End an ongoing call, and answer a call on another phone
Press
Put an ongoing call on hold, and answer a call on another phone
Press and hold for 2 seconds.
Switch between active and held calls
Press and hold for 2 seconds.
End an ongoing call, and activate a held call
Press
.
.
If you redial or use voice dialling, the call is made on the phone you last had an active
call on with the headset.
9
Settings
Clear device pairings
1
2
To switch the headset off, press and hold
Press and hold for 9 seconds. The headset beeps twice, and the red and green
indicator lights alternate.
for 5 seconds.
After the pairings are cleared, the headset enters pairing mode.
Product and safety information
Battery and charger information
This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as
you may damage the device.
This device is intended for use when supplied with power from the following chargers: AC–11, AC-3, AC-8, AC-15, DC-4. The
exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following:
E, X, AR, U, A, C, K, B, or N.
The battery can be charged and discharged hundreds of times, but it will eventually wear out.
Talk and standby times are estimates only. Actual times are affected by, for example, device settings, features being used,
battery condition, and temperature.
If the battery has not been used for a long time, to begin charging, you may need to connect the charger, then disconnect
and reconnect it.
If the battery is completely discharged, it may take several minutes before the charging indicator is displayed.
When your charger is not in use, unplug it from the electrical plug and the device. Do not leave a fully charged battery
connected to a charger, as overcharging may shorten the battery’s lifetime. If left unused, a fully charged battery will lose
its charge over time.
Always keep the battery between 15°C and 25°C (59°F and 77°F). Extreme temperatures reduce the capacity and lifetime
of the battery. A device with a hot or cold battery may not work temporarily.
Do not dispose of batteries in a fire as they may explode. Dispose of batteries according to local regulations. Recycle when
possible. Do not dispose as household waste.
Use the charger for its intended purpose only. Improper use or use of unapproved chargers may present a risk of fire,
explosion, or other hazard, and may invalidate any approval or warranty. If you believe the charger is damaged, take it to a
service centre for inspection before continuing to use it. Never use a damaged charger. Only use the charger indoors.
Take care of your device
Handle your device, charger and accessories with care. The following suggestions help you protect your warranty coverage.
•
Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode
electronic circuits. If your device gets wet, allow the device to dry.
•
•
Do not use or store the device in dusty or dirty areas. Moving parts and electronic components can be damaged.
Do not store the device in cold temperatures. When the device warms to its normal temperature, moisture can form
inside the device and damage electronic circuits.
10
•
•
•
•
Do not attempt to open the device.
Unauthorised modifications may damage the device and violate regulations governing radio devices.
Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and mechanics.
Only use a soft, clean, dry cloth to clean the surface of the device.
Recycle
Always return your used electronic products, batteries, and packaging materials to dedicated collection points. This way
you help prevent uncontrolled waste disposal and promote the recycling of materials. Check how to recycle your Nokia
products at www.nokia.com/recycling.
Crossed-out wheeled-bin symbol
The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and
electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This
requirement applies in the European Union. Do not dispose of these products as unsorted municipal waste. For more
environmental information, see the product Eco profile at www.nokia.com/ecoprofile.
Copyright and other notices
DECLARATION OF CONFORMITY
Hereby, NOKIA CORPORATION declares that this BH-118 product is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/
© 2012 Nokia. All rights reserved.
Nokia, Nokia Connecting People, and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia
Corporation.
Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior
written permission of Nokia is prohibited. Nokia operates a policy of continuous development. Nokia reserves the right to
make changes and improvements to any of the products described in this document without prior notice.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Nokia is under license.
To the maximum extent permitted by applicable law, under no circumstances shall Nokia or any of its licensors be responsible
for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.
The contents of this document are provided "as is". Except as required by applicable law, no warranties of any kind, either
express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular
purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise
this document or withdraw it at any time without prior notice.
The availability of products may vary by region. For more information, contact your Nokia dealer. This device may contain
commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion
contrary to law is prohibited.
11
/Issue 1.0 EN
|